PUSH
Use a cuticle pusher to gently push back the cuticles.
🔎 Note: Do not apply too much force to avoid injuring the nail bed.
BUFF
Use a buffer to lightly roughen the surface of the nail.
🔎 Note: It’s recommended to use the coarse side of the buffer.
WIPE
Wipe the nail surface thoroughly with an alcohol pad.
🔎 Note: Make sure the nail surface is dry, dust-free, and oil-free — this step determines how long the nails will last.
COMPARE
Place each press-on nail over your natural nail to find the best fit.
🔎 Note: If your nail surface is relatively flat, you can layer a smaller jelly tab on the nail to create a slight arch so the press-on fits better.
APPLY
Peel off the jelly tab and place it on your nail.
🔎 Note: Avoid letting the adhesive touch your skin or cuticles, or it may lift at the edges.
HEAT
Use a hairdryer on a low setting to blow warm air on the nail for a few seconds to soften the adhesive and make it more pliable.
🔎 Note: Do not use high heat to prevent hurting your hands or affecting the glue’s performance.
PICK
Carefully pick up the press-on nail, ready to apply.
🔎 Note: Try not to touch the adhesive surface with your fingers to keep it clean.
ON
Align the press-on nail to the edge of your natural nail and gently lay it down.
🔎 Note: Hold the press-on at a 45-degree angle and press from the cuticle area toward the tip to push out any air bubbles. Avoid misplacing and reapplying repeatedly.
PRESS
Press the nail down evenly and firmly for 20–30 seconds to secure it.
🔎 Note: Pay extra attention to pressing down the sides and the tip to prevent lifting.
CARE
Apply a bit of cuticle oil or lotion around your nails to keep them moisturized.
🔎 Note: Avoid soaking your hands in water for long periods, forcefully prying off the nails, or using your nails as tools.
DONE
After installation, check each nail to ensure it is securely attached.
